Grant Aerona R290 fault P01
Air in system or low water level
Heat pumpWhat it means
Displayed on the touch screen display during initial switch on, indicating a possible air ingress in the system or that the water level in the system is below the required minimum.
Likely causes
- Air trapped in the system
- Water level in system less than the required minimum
Where to start
- Check system water level
- Bleed air from system via automatic air vent
The full answer, free
- How to put it right, step by step
- The manual page for this fault (page 52), right under the answer
Safety: Isolate the outdoor unit and any backup heater, and give the inverter capacitors time to discharge before you open the electrics. Anything on the refrigerant circuit needs F-gas certification.
From the Grant manual for the Aerona R290. Check the model on the data plate before you order parts.
Other Grant Aerona R290 fault codes
- 1Pump over-voltage protection
- 2Pump under-voltage protection
- 3Pump over-current protection
- 4Pump light-load protection
- 5Pump phase loss protection
- 6Pump block protection
- 7Pump over-temperature protection
- E01Connection fault between wiring centre and heat pump
- E34AC input voltage is abnormal
- E35Drive EEPROM error
- E36Power off reset
- E37Reserved
- E38Reserved
- E57Gas sensor offline
- E58Gas sensor