Immergas Victrix fault 60

What it means

The pump is stopped due to one of the following causes: Impeller blocked, electrical fault.

Likely causes

1. Impeller blocked
2. Electrical fault in pump
3. Low power supply voltage
4. Rotor seized
5. Electrical error in pump
6. Lack of water in the appliance
7. Little water circulation in the system
8. Blocked pump
9. Disconnected PWM signal wire (when boiler is requesting ignition but pump stays in stand-by)
10. Disconnection of the PWM control signal between PCB and pump
11. Boiler electronics not requesting pump ignition (normal, condition OK)
12. Boiler electronics requesting pump ignition but pump not responding (faulty condition, probable disconnection of the PWM signal)
13. Blocked pump (Par. 1.29)
14. Drain trap not yet filled with condensate on first start-up, allowing combustion products to escape via condensate drain
15. Long period of inactivity causing pump/rotor seizure

Where to start

1. Attempt to unblock the pump as described in the relative section
2. Check for debris or blockage in pump impeller
3. Verify electrical connections to pump