Immergas Victrix fault E60

What it means

Pump detects an alarm condition, indicated by the pump's alarm symbol (1) lighting up red. Signalled on boiler display as E60.

Likely causes

1. Low power supply voltage
2. Rotor seized
3. Electrical error in pump
4. Impeller blocked
5. Electrical fault in pump
6. Disconnected PWM signal wire (when boiler is requesting ignition but pump stays in stand-by)
7. Disconnection of the PWM control signal between PCB and pump
8. Boiler electronics not requesting pump ignition (normal, condition OK)
9. Boiler electronics requesting pump ignition but pump not responding (faulty condition, probable disconnection of the PWM signal)
10. Long period of inactivity causing pump/rotor seizure
11. Lack of water in the appliance
12. Little water circulation in the system
13. Blocked pump
14. Blocked pump (Par. 1.29)
15. Drain trap not yet filled with condensate on first start-up, allowing combustion products to escape via condensate drain

Where to start

1. Check pump alarm symbol (1) for red illumination
2. Check power supply voltage to the pump
3. Check if rotor is seized by attempting manual release via centre screw